Interrupt service routines for INT0, INT1, INT2 in enCoReII
Anonymous
Not applicable
Sep 24, 2009
07:47 AM
- Subscribe to RSS Feed
- Mark as New
- Mark as Read
- Bookmark
- Subscribe
- Printer Friendly Page
- Report Inappropriate Content
Sep 24, 2009
07:47 AM
Question: Where are the Interrupt Service Routines of the pin specific interrupts INT0, INT1 and INT2 located?
Answer:
The boot.tpl file of the encoreII project will contain the Interrupt Service Routines for enCoRe II GPIO interrupts: INT0, INT1, INT2.
Rate this article:
Contributors
-
This widget could not be displayed.Anonymous