Strictly necessary cookies are on by default and cannot be turned off. Functional, Performance and Tracking/targeting/sharing cookies can be turned on below based on your preferences (this banner will remain available for you to accept cookies). You may change your cookie settings by deleting cookies from your browser. Then this banner will appear again. You can learn more details about cookies HERE.
Strictly necessary (always on)
Functional, Performance and Tracking/targeting/sharing (default off)
Initial Check and Setup Request for Solar-Powered BLE Sensor Beacon Reference Design Kit (RDK) CYALKIT-E02 Rev. ** - KBA216026
This document requests an initial check and setup for the CYALKIT-E02 Rev**, because some of Rev. ** kits have different values from the default values listed in the CYALKIT-E02 Kit Guide. To check the revision of your kit, refer to following pictures.
Initial Check and Setup for Rev. **
Please check the following items in your kit.
The default value that is defined in the kit guide is 0x0001. Even if the value of your kit is different, you can use this value as it is. Refer to page 26 of the CYALKIT-E02 Kit Guide on how to check and set up the value.
Transmitter power strength (TXPWR)
The default value that is defined in the kit guide is 3 dBm. If the value of your kit is different, the distance of a transmitting signal might be shorter. It is recommended that you change the value to the default value in that case. Refer to page 32 of the CYALKIT-E02 Kit Guide on how to check and set up the value.
For assistance, go to www.cypress.com/support or contact our customer support at +1 (800) 541-4736 Ext. 2 (in the USA), or +1 (408) 943-2600 Ext. 2 (International).