GPIO interrupts
Anonymous
Not applicable
Dec 19, 2008
12:00 AM
- Subscribe to RSS Feed
- Mark as New
- Mark as Read
- Bookmark
- Subscribe
- Printer Friendly Page
- Report Inappropriate Content
Dec 19, 2008
12:00 AM
Question: Occasionally when constant GPIO interrupts occur, the CY3654 will halt. This has been found to happen most often at an 800Hz interrupt rate. The halt can happen anywhere from a couple of seconds to 10 minutes after the first GPIO interrupt.
Answer:
This is a known problem with the CY3654. We're still investigating the cause. Please refer to the CY3654-P05 errata for a list of known issues. Open a support case for this document.
Rate this article:
Contributors
-
This widget could not be displayed.Anonymous