GPIF Data Transfer Failure during ZLP – KBA90259
Anonymous
Not applicable
Jan 29, 2014
11:43 PM
- Subscribe to RSS Feed
- Mark as New
- Mark as Read
- Bookmark
- Subscribe
- Printer Friendly Page
- Report Inappropriate Content
Jan 29, 2014
11:43 PM
Version: **
Question: Why does the GPIF data transfer fail during a zero-length packet (ZLP)?
Answer:
Some data transfer errors may be seen if a ZLP is followed very quickly (for example, within one microframe or 125 μs) by another data packet on a burst-enabled USB IN endpoint operating at Super Speed.
The solution is to ensure that you allow some time to elapse between a ZLP and the next data packet on burst-enabled USB IN endpoints.
Labels
Rate this article:
Contributors
-
This widget could not be displayed.Anonymous