GAL code file does not match CY3684 Schematic
Anonymous
Not applicable
Dec 19, 2008
12:00 AM
- Subscribe to RSS Feed
- Mark as New
- Mark as Read
- Bookmark
- Subscribe
- Printer Friendly Page
- Report Inappropriate Content
Dec 19, 2008
12:00 AM
Question: The EZ-USB Development Kit Manual - Getting Started pdf on page 19 contains the GAL code. Under the Input section CLKOUT is assigned pin 2. The schematic shows nRD going to pin 2. Which is correct?
Answer:
The schematic is correct. CLKOUT in the Input and the equations sections should be replace with nRD.
Rate this article:
Contributors
-
This widget could not be displayed.Anonymous