Functionality Problem with Ultra37000V CPLD Despite Passing Simulation
Anonymous
Not applicable
Jan 01, 2012
05:13 PM
- Subscribe to RSS Feed
- Mark as New
- Mark as Read
- Bookmark
- Subscribe
- Printer Friendly Page
- Report Inappropriate Content
Jan 01, 2012
05:13 PM
Question: 1. A pin gets pulled low even though the simulation shows it correct? 2. I get daisy chain errors, why?
Answer:
Please check the power supply voltages. There are instances where a 5V power supply has been used on a 3.3V (V) part, and this resulted in functionality issues on a few pins. This difference in power supplies can also result in failed daisy chain errors when programming.
Please be noted our entire Cypress CPLD product are Obsolete and not recommended for new design and development. For more information on CPLD product, please visit our webpage:http://www.cypress.com/go/cpld
Labels
- Tags:
- phys
Rate this article:
Contributors
-
This widget could not be displayed.Anonymous