Tip / Sign in to post questions, reply, level up, and achieve exciting badges. Know more

cross mob

External pull-up for FX1/FX2LP

External pull-up for FX1/FX2LP

Anonymous
Not applicable
Question: When the FX1 is operated from 3.3V Vcc, can an output port be pulled to +5V using an external pullup?

 

Answer:

Yes, the output port can be pulled to +5V using an external pullup. For this, you need to configure your EZ-USB I/O pins as open-collector outputs with pullup resistors to 5V. To make a pin act as an open-collector output, set the appropriate OUTx bit to 0, then toggle the corresponding OEx bit to switch the pin between low (output) and high-impedance (input) states.

0 Likes
316 Views
Contributors