EZ-USB® HX2VL™ Crystal Stopping after the Hub Out from Reset – KBA87757
Anonymous
Not applicable
Mar 18, 2014
01:06 AM
- Subscribe to RSS Feed
- Mark as New
- Mark as Read
- Bookmark
- Subscribe
- Printer Friendly Page
- Report Inappropriate Content
Mar 18, 2014
01:06 AM
Version: **
Question: Why does the USB® HX2VL™ crystal stop after the hub out from reset?
Answer:
The crystal stops operation in Suspend mode. When there is no activity on the upstream USB bus for more than 3 ms, HX2VL enters suspend mode. Therefore, when you reset HX2VL with no devices connected to any of the downstream ports, HX2VL goes into Suspend mode and the crystal stops operation.
Rate this article:
Contributors
-
This widget could not be displayed.Anonymous