Translation - Japanese: PSoC 3/ PSoC 5LPの設計およびプログラミングチェックリスト – KBA208166 - Community Translated (JA)
What are the minimum connections to do for designing PSoC 3/ PSoC 5LP board to program it properly with MiniProg3?
Ensure the following with your PSoC 3/ PSoC 5LP designs before you program the project. Fig 1 shows the connections of all voltages (VDD, VDDD, VDDA, VDDIO0 to VDDIO3) and ground (VSS) pins.
Fig 1: Voltage and Ground Connections for PSoC 3/ PSoC 5LP Device
1) For programming the PSoC device with MiniProg3 using the SWD protocol, ensure the following connections. SWD protocol can work with 5-pin connector as well as with 10-pin connector of MiniProg3.
Note: VDD here means all power pins like VDDD, VDDA, VDDIO0, VDDIO1, VDDIO2, and VDDIO3.
2) For programming it with MiniProg3 using the JTAG protocol, make the following connections. All points specified for SWD protocol are valid for the JTAG protocol also.
For more information, see the schematic of CY8CKIT-030 available at http://www.cypress.com/documentation/developmentkitsboards/cy8ckit-030-psoc-3-development-kit.