Debugging PSoC® Devices When the Debug Select Option Is Set to GPIO - KBA91118
Anonymous
Not applicable
May 02, 2014
02:48 AM
- Subscribe to RSS Feed
- Mark as New
- Mark as Read
- Bookmark
- Subscribe
- Printer Friendly Page
- Report Inappropriate Content
May 02, 2014
02:48 AM
Version: **
Question: Is it possible to debug PSoC® 3/ PSoC 4/ PSoC 5LP devices if the Debug Select option in the project_name.cydwr file is set to GPIO?
Answer:
It is possible to debug PSoC 3 and PSoC 5LP devices when the Debug Select option in the System tab of the project_name.cydwr file is set to GPIO, but attaching it to the running target is not possible. But in the case of PSoC 4 devices, both debugging and attaching to the running target are not possible if the Debug Select option in the System tab of the project_name.cydwr file is set to GPIO.
Labels
Rate this article:
Contributors
-
This widget could not be displayed.Anonymous