Strictly necessary cookies are on by default and cannot be turned off. Functional, Performance and Tracking/targeting/sharing cookies can be turned on below based on your preferences (this banner will remain available for you to accept cookies). You may change your cookie settings by deleting cookies from your browser. Then this banner will appear again. You can learn more details about cookies HERE.
Strictly necessary (always on)
Functional, Performance and Tracking/targeting/sharing (default off)
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
Knowledge Base Articles
- Home
- General
- Knowledge Base Articles
- Data Transfer between the Internal FIFOs and an Ex...
Options
- Article History
- Subscribe to RSS Feed
- Mark as New
- Mark as Read
- Bookmark
- Subscribe
- Email to a Friend
- Printer Friendly Page
- Report Inappropriate Content
Data Transfer between the Internal FIFOs and an External Memory Device in FX2/FX2LP
Anonymous
Not applicable
Apr 04, 2011
06:38 AM
- Subscribe to RSS Feed
- Mark as New
- Mark as Read
- Bookmark
- Subscribe
- Email to a Friend
- Printer Friendly Page
- Report Inappropriate Content
Data Transfer between the Internal FIFOs and an External Memory Device in FX2/FX2LP
Question: Can FX2/FX2LP transfer data between its internal FIFOs and an external memory device?
Answer:
FX2 can use the GPIF to connect up to almost any external slave device. The first thing to do is determine the hardware interface between the GPIF and the external memory device. You must decide whether there are enough GPIF address lines available to connect to the external memory device.
Please read through the GPIF chapter in the FX2 Technical Reference Manual. In addition, please refer to the application note, EZ-USB® FX2LP™ GPIF Design Guide - AN66806.
Labels
Rate this article:
Version history
Contributors
-
Anonymous