Connecting the GDVdd, Vdd, and AVdd when using the Built-in Switching Regulator
Level 5
Jul 01, 2010
03:41 AM
- Subscribe to RSS Feed
- Mark as New
- Mark as Read
- Bookmark
- Subscribe
- Printer Friendly Page
- Report Inappropriate Content
Jul 01, 2010
03:41 AM
Question: If I am using the Built-in Switching Regulator, do I still connect the GDVdd, Vdd, and AVdd?
Answer:
When the Built-in Switching Regulator is used, it is necessary to connect the output of the 5V regulator to GDVdd, Vdd, and AVdd externally to power up the PowerPSoC device.
Rate this article: