Connecting the ADV/LD# Pin in Synchronous NoBL SRAMs to a Static Level - KBA83097
Employee
Sep 01, 2011
09:16 AM
- Subscribe to RSS Feed
- Mark as New
- Mark as Read
- Bookmark
- Subscribe
- Printer Friendly Page
- Report Inappropriate Content
Sep 01, 2011
09:16 AM
Version: *A
Translation - Japanese: 同期NoBL SRAMのADV/LD#ピンの静的レベルとの接続について - KBA83097- Community Translated (JA)
Question:
Can I connect the ADV/LD# pin in synchronous NoBL SRAMs to a static level? Should I toggle it during normal operation?
Answer:
Yes, you can connect the ADV/LD# pin to a static level. You do not have to toggle it during normal operation. When ADV/LD# is tied HIGH (and CEN is asserted LOW), the address automatically increments during a burst cycle. When ADV/LD# is tied LOW, you can load a new address into the device for each access.
Labels
- Tags:
- synchronous srams
Rate this article: