Configuring Unused Buttons - KBA82818
Anonymous
Not applicable
Jan 01, 2012
07:51 AM
- Subscribe to RSS Feed
- Mark as New
- Mark as Read
- Bookmark
- Subscribe
- Printer Friendly Page
- Report Inappropriate Content
Jan 01, 2012
07:51 AM
Version: **
Question: I have a PCB layout that is used for multiple projects, however, a few CapSense buttons are not used in every project. In these projects, the unused buttons are on the PCB but they are not defined on the overlay artwork. What is the right pin configuration for these buttons in PSoC Designer?
Answer:
The GPIO setting for the unused button inputs need to be configured as "Strong" and driven low. These pins should not be configured as buttons in the designer project. Often, the default designer setting is "Hi Z", but this may cause a problem if the unused buttons are capacitively coupled to adjacent buttons in the Hi Z state.
Labels
Rate this article:
Contributors
-
This widget could not be displayed.Anonymous