Compact Flash (CF) media change detection with the CY4611 board.
Anonymous
Not applicable
Apr 04, 2011
07:09 AM
- Subscribe to RSS Feed
- Mark as New
- Mark as Read
- Bookmark
- Subscribe
- Printer Friendly Page
- Report Inappropriate Content
Apr 04, 2011
07:09 AM
Question: Compact Flash (CF) media change is not always detected with the CY4611 board.why?
Answer:
Many CompactFlash devices do not tie the CE1# signal directly to ground. Some of these devices will not pull CD1# strongly enough to pull the voltage divider below VIL. To address this issue change R18 to 2.2K. Cypress has made a BOM change on boards produced after May 2003 to address this issue.This issue is also fixed in CY4611B http://www.cypress.com/?rID=14406
Rate this article:
Contributors
-
This widget could not be displayed.Anonymous