CapSense® Tuner Checksum Mismatch Error - KBA219754
Anonymous
Not applicable
Jun 02, 2017
02:11 AM
- Subscribe to RSS Feed
- Mark as New
- Mark as Read
- Bookmark
- Subscribe
- Printer Friendly Page
- Report Inappropriate Content
Jun 02, 2017
02:11 AM
Version: **
Translation - Japanese: CapSense®チューナーチェックサム不一致エラー - KBA219754 - Community Translated (JA)
Question:
Why does the checksum mismatch error occur in CapSense tuner?
Answer:
When you run the tuner, you may get the following message “Checksum mismatch for the data stored in the device”
The CapSense tuner requires the checksum stored in the device to match with the checksum from the tuner. When a mismatch occurs, this above error is displayed.
One of the possible reason is if you set sub-address as 8-bit in the EZI2C Component and 16-bit in tuner configuration. You should always set the sub-address to 16-bits.
Rate this article:
Contributors
-
This widget could not be displayed.Anonymous