cancel
Showing results for 
Search instead for 
Did you mean: 

Knowledge Base Articles

Can the Vi/o signal be disconnected while VCC is fully applied after the FLASH enters Standby/Auto Sleep Mode/Deep Power Down mode? - -KBA203730

Anonymous
Not applicable

Can the Vi/o signal be disconnected while VCC is fully applied after the FLASH enters Standby/Auto Sleep Mode/Deep Power Down mode? - -KBA203730

Version: *A

Translation - Japanese: Flash Memoryがスタンバイモード、オートスリープモード、ディープパワーダウンモードに入った後、VCCが完全に満足されている状況でVIOを未接続にできますか? - KBA203730 - Co...

Question:

Can the VIO signal be disconnected while VCC is powered up after Flash enters Standby Mode, Auto Sleep Mode, or Deep Power Down mode?

Answer:

Yes, but this is a datasheet violation and is not the best practice.

There is no risk of damage to the Flash when VIO is removed when the Flash is in any powered state. However, doing so will cause the Flash to enter an undefined state, and may not reduce power consumption. The recommended recovery from the undefined state is power-on reset (POR).

0 Likes
Version history
Revision #:
1 of 1
Last update:
‎Oct 11, 2015 11:18 PM
Updated by:
Anonymous
 
Contributors