Strictly necessary cookies are on by default and cannot be turned off. Functional, Performance and Tracking/targeting/sharing cookies can be turned on below based on your preferences (this banner will remain available for you to accept cookies). You may change your cookie settings by deleting cookies from your browser. Then this banner will appear again. You can learn more details about cookies HERE.
Strictly necessary (always on)
Functional, Performance and Tracking/targeting/sharing (default off)
The CY8CKIT-042-BLE Pioneer Kit example projects do not work after I upgrade to PSoC® Creator™ 3.1 Production Release (build 1570).
The CY8CKIT-042-BLE Pioneer Kit has three Cypress BLE devices:
CY8C4247LQI-BL483 (CY8CKIT-142 PSoC 4 BLE Module)
CYBL10563-56LQXI (CY5671 PRoC BLE Module)
CYBL10162-56LQXI (CY5670 CySmart USB Dongle)
PSoC 4 BLE and PRoC BLE are the first BLE devices introduced by Cypress in Nov 2014.
A few customers have observed that some devices fail BLE connectivity tests. Cypress has analyzed the failures and identified that the problem was due to improper manufacturing trim-register settings. A new version of PSoC Creator has been released to correct the trim-register settings, allowing the devices to function as expected. The manufacturing trim-register settings are corrected for all new devices shipped after 01/31/2015. For devices that were shipped previously, Cypress recommends that customers use the latest release of PSoC Creator to ensure all devices function as expected. You can download and install the latest version of PSoC Creator (Version 3.1 Component Pack 1 or later) from www.cypress.com/psoccreator/.
Some BLE Pioneer Kits use devices from the affected lots; to correct this, a new kit software installer (Rev *A) with PSoC Creator 3.1 Component Pack 1 is available for download from www.cypress.com/cy8ckit042ble.
After the kit is programmed with the updated example projects using PSoC Creator 3.1 Component Pack 1, the radio failures will be fixed. If problems persist, contact Cypress technical support at email@example.com.