CY3671 EZ-USB FX Firmware Memory Setting
Anonymous
Not applicable
Dec 19, 2008
12:00 AM
- Subscribe to RSS Feed
- Mark as New
- Mark as Read
- Bookmark
- Subscribe
- Printer Friendly Page
- Report Inappropriate Content
Dec 19, 2008
12:00 AM
Question: Using the CY3671 EZ-USB FX development kit and the evaluation version of the Keil tools that are included with the CY3671 development kit then how to change where the firmware will be located in memory when it is downloaded?
Answer:
To change the location where your firmware is loaded ensure 'Target 1' is highlighted in the Project window. Select Project from the top menu bar. A drop down menu will appear. Select 'Options for Target 'Target 1'. You can now select the L51 Locate tab and specify the desired location for code and xdata. We recommend that you do not place code below 0x80 to ensure you do not step on the USB jump table.
Rate this article:
Contributors
-
This widget could not be displayed.Anonymous