Strictly necessary cookies are on by default and cannot be turned off. Functional, Performance and Tracking/targeting/sharing cookies can be turned on below based on your preferences (this banner will remain available for you to accept cookies). You may change your cookie settings by deleting cookies from your browser. Then this banner will appear again. You can learn more details about cookies HERE.
Strictly necessary (always on)
Functional, Performance and Tracking/targeting/sharing (default off)
OK
Reject
Help
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 

Knowledge Base Articles

+B Signal Input in Traveo S6J3XXX Series and CY9D560 Series MCUs – KBA217785

Anonymous
Not applicable
‎Dec 29, 2016 12:57 AM

+B Signal Input in Traveo S6J3XXX Series and CY9D560 Series MCUs – KBA217785

Version: *A

Translation - Japanese: Traveo S6J3XXXシリーズおよびCY9D560シリーズMCUの＋B信号入力 - KBA217785 - Community Translated (JA)

Question:

Is the +B signal input supported in Traveo™ S6J3110/3120/3200/3300/3350/3360/3370/3400/3510 Series and CY9D560 Series MCUs?

Answer:

Yes. Connect a limiting resistor between the +B signal and the MCU within the recommended operating conditions. See the following datasheets for details.

Datasheets:

Note:

This knowledge base article applies to the following series of Traveo MCUs:

  • S6J3110
  • S6J3120
  • S6J3200
  • S6J3300
  • S6J3350
  • S6J3360
  • S6J3370
  • S6J3400
  • S6J3510
  • CY9D560

The prefix MB of the product has been changed to CY. For instance, MB9D560 has been changed to CY9D560.

0 Likes
Rate this article:
Version history
Revision #:
1 of 1
Last update:
‎Dec 29, 2016 12:57 AM
Updated by:
Anonymous
 
View article history
Contributors