Adding Superspeed MUX in CCGx Application Project – KBA229149
Employee
Dec 10, 2019
11:17 PM
- Subscribe to RSS Feed
- Mark as New
- Mark as Read
- Bookmark
- Subscribe
- Printer Friendly Page
- Report Inappropriate Content
Dec 10, 2019
11:17 PM
Author: LisaZ_26 Version: **
Translation - Japanese:CCGxアプリケーションプロジェクトにSuperspeed MUXを追加する – KBA229149 - Community Translated (JA)
Question:
Is additional Superspeed MUX required to design a CCGx Application Project?
Answer:
Yes. Additional superspeed MUX is required if you are designing a Type-C receptacle and supporting the USB3.0/DisplayPort/HDMI/TBT3/4 because the pin assignment of USB3.0/DisplayPort/HDMI/TBT3/4 is done based on the CC orientation of Type-C partner plugin. Alternately, you could save the superspeed MUX in any of the following plugins:
- Type-C plug interface
- Type-C receptacle supporting USB2.0 only
- Firmware developing on USB3.0 host/device
- Firmware developing on DisplayPort source CPU
Labels
Rate this article: