AUTOPTR
Anonymous
Not applicable
Dec 19, 2008
12:00 AM
- Subscribe to RSS Feed
- Mark as New
- Mark as Read
- Bookmark
- Subscribe
- Printer Friendly Page
- Report Inappropriate Content
Dec 19, 2008
12:00 AM
Question: Is AUTOPTR only used only for moving data from/to bulk/iso endpoints?
Answer:
No.You can write the any RAM address of the source/destination to the Autopointer register. Any access of the AUTODATA register will result in incrementing the value stored n the autopointer register.Please see chapter 8 of the TRM section 8.8 in particular.
Rate this article:
Contributors
-
This widget could not be displayed.Anonymous