Jul 28, 2021
11:06 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jul 28, 2021
11:06 PM
Hi,
When I use s26kl512s hyperflash model, i meet some problem about < word program command > .
I send command as below: the Status_reg[7] is always 1 indicating that flash is in ready state.
After CS de-asserted, Status_reg[7] always is 1.
As i known, when i send word program command, the Status_reg[7] shall be 0 to indicate flash busy.
How this happened? and what problem is in my command sequences?
Thanks
Solved! Go to Solution.
Labels
- Labels:
-
Memory Hyper Flash
1 Solution
Jul 29, 2021
08:16 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jul 29, 2021
08:16 PM
Oh, I found my third transaction 's address is 0x55, but right address is 0x555.
I have solved the problem.
Thanks.
2 Replies
Jul 29, 2021
08:52 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jul 29, 2021
08:52 AM
Hello,
Thank you for contacting Cypress Technical Support, an Infineon Technologies Company. Currently we are viewing your issue and will get back to you as soon as we find the resolution.
Thank you
Regards,
Bushra
Jul 29, 2021
08:16 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jul 29, 2021
08:16 PM
Oh, I found my third transaction 's address is 0x55, but right address is 0x555.
I have solved the problem.
Thanks.