MCU does not start

Tip / Sign in to post questions, reply, level up, and achieve exciting badges. Know more

cross mob
Anonymous
Not applicable

I'm using the FM3 MCU MB9BF516N for several PCBs.

I have now some PCBs not working.

It seems that the MCU does not start, because I also get no connection with the Debugger using SWD.

What could be the reason?

In the datasheet I found in chapter 12.4.7 Power-on Reset Timing the following:

Power ramp rate dV/dt (Vcc: 0.2V to 2.7V) Min 0.8 mV/µs, Max: 1000 mV/µs

Is this a condition for proper startup of the MCU?

In other words: If the power Ramp on Vcc is slower than 0.8 mV/µs, could startup of the CPU fail?

0 Likes
1 Solution
ShipingW_81
Moderator
Moderator
Moderator
500 replies posted 250 solutions authored 250 replies posted

Yes, it's possible the reason.

Please follow the power-on reset timing spec on Vcc ramp rate, and then let me know if it helps.

View solution in original post

0 Likes
2 Replies
ShipingW_81
Moderator
Moderator
Moderator
500 replies posted 250 solutions authored 250 replies posted

Yes, it's possible the reason.

Please follow the power-on reset timing spec on Vcc ramp rate, and then let me know if it helps.

0 Likes
Anonymous
Not applicable

Yes it's the reason. but I'll use now an microcontroller supervisory circuit for external reset signal to ensure proper startup

0 Likes