cancel
Showing results for 
Search instead for 
Did you mean: 

FM0+, FM3 & FM4 MCU

TeMa_2997106
Contributor II

I want to check the failure mode of the MCU to comply with IEC60335 (safety standard).

Please let me know if any of the following failure modes of the S6E2H14 port are not considered (it is considered that they will not occur).

1) High sticking
2) Low sticking
3) Sticking to intermediate potentials other than High / Low
4) Randomly fluctuates (High / Low switches randomly)

Also, are there any other port failure modes that are considered?

Thanks,
Tetsuo

0 Likes
1 Solution
TakashiM_61
Moderator
Moderator

Dear author,

We checked this topic internally, but it is difficult to continue the discussion in CDC (i.e. public space).

So, could you please contact to IFX/CY sales representative on this topic?

it would be appreciated if you understand this.

View solution in original post

0 Likes
1 Reply
TakashiM_61
Moderator
Moderator

Dear author,

We checked this topic internally, but it is difficult to continue the discussion in CDC (i.e. public space).

So, could you please contact to IFX/CY sales representative on this topic?

it would be appreciated if you understand this.

View solution in original post

0 Likes
Top labels