cancel
Showing results for 
Search instead for 
Did you mean: 

FM0+, FM3 & FM4 MCU

SuSh_1535366
New Contributor II

Hello,

We are going to use a board inspection system to inspect the mounting status of the board using CY9BF122KPMC-G-JNE2.

In order to detect solder bridges and solder defects, 1.5V is applied between each pin for 0.5 seconds (There is no power on the board).

Is there any problem with this operation?

Also, please let us know if there is a restriction for each pin.

Regards,

Shimamura

0 Likes
Reply
1 Solution
TakashiM_61
Moderator
Moderator

Dear Shimamura-san,

For the FM3 device itself, if you follow the Absolute Maximum Ratings described in datasheet of CY9B120M Series, it would be no problem.

thank you.

View solution in original post

0 Likes
Reply
1 Reply
TakashiM_61
Moderator
Moderator

Dear Shimamura-san,

For the FM3 device itself, if you follow the Absolute Maximum Ratings described in datasheet of CY9B120M Series, it would be no problem.

thank you.

View solution in original post

0 Likes
Reply
Top labels