- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello all,
The project from the below GitHub link shows how to design a Digital Read Out (DRO) (used in the Mills/Lathe machines) using a PSoC 6 BLE device. A DRO is simply a digital reading of the scale along the axis in the mill or lathe. Usually, it is the X-, Y- and Z- axis for a milling machine, and X- and Z- axis for lathes. Linear encoders which output the position of the scale can be fixed on the axes of these machines and can be connected to a DRO. This PSoC 6 BLE DRO measures the position of all the three axes and sends the data over BLE to an Android App.
Schematic Diagram:
Hardware Required: CY8CKIT-062-BLE PSoC 6 BLE Pioneer Kit
Software Required: PSoC Creator 4.3
PSoC Creator project, Android App and project datasheet are attached in the below GitHub page.
GitHub link: PSoC6 BLE DRO for Mills and Lathe machines
Thanks,
P Yugandhar.
- Labels:
-
PSoC 6
- Tags:
- : psoc6 ble
- android app
- bluetooth low energy 5.0
- look up table
- psoc creator 4.3
- quad decoder
- scb uart
- timer component