cancel
Showing results for 
Search instead for 
Did you mean: 

Clocks

Anonymous
Not applicable

Hi.
We bought some cy22801 chips from our chip provider.
But the function is not the same as what we want.
We want the chip to behave as I2C slave, then each power-up, our I2C master can re-write its internal registers. But from out test, pin #5 is clkB output.
From the datasheet, we should generate JEDEC file through CyClocksRT, and then download it using CY36800 programmer.   Then cy22801 would be changed to be I2C mode. Is it correct?
 

0 Likes
Reply
1 Reply
Esteemed Contributor II

As I understood the datasheet this are the exact steps to setup your device.

   

When you feel a bit unsure about, do not hesitate to create a support case: On top of this page Design support -> Create a Support Case

   

 

   

Bob

0 Likes
Reply