We have been using your CY23FS04 in our product to pass/maintain a 16Mhz clock over a long cable so that the clock is fully in sync over the system, even when the clock signal has a glitch due to signal quality.
With the obsolete of CY23FS04, do you have any replacement/recommendation for such purpose?
Thanks for your reply!
Would you recommend programming kit for CY3672, CY3675A or CY22381 ?
If Cypress' programming kit due to the fact that is obsolete is phased out, please give me your recommended any brand 's programming kit which can support these items.
Thanks and regards,
Hello I bought some time ago an Instatclock CY36800 kit with 5 cy22800 circuits.
To be able to program more than these 5 components it is requested to register in the software
but the link is not successful.
Can you help me. I am already registered on the Cypress site. Thank you
Good morning Like the title, I am using the cy2dl1504zxc(i) model, which is marked as obsolete in the distributor (mouser).
Whether it’s not producing additionally, I am curious if there will be a model change after the merger.
Please reply. work hard. email@example.comShow Less
We are using the cypress part CY22393FXI in our design, now it has become absolute, we are looking for the alternative part and the new part EOL should not be less than 10 years from now, please provide the solution asap.
Awaiting for your response,
We are currently working in a new project and it is having clock section. Below mentioned clock block diagram for your reference.
Can you please refer this block and provide the best suitable parts for this requirement? Also please let me know, if you need any inputs.
I'm interested in the 1:10 clock buffer CY2DL15110. It is not written on the site and not in datasheet, what is the
status of the device ? Is it in "Active" "Production" or may be it is "obsolete".
Can you please tell what is the status of CY2DL15110 ?
Should the connection to FBIN be taken into account as the load to the output pins?
For example, if FBIN is derived from OUT2, can OUT2 also be used to connect directly to another component, e.g. an ADC clock input?
If this load is acceptable, would this affect zero input-output delay performance?
Should instead use a 1:2 fanout buffer from OUT2 and from it fanout to FBIN and the ADC?
Thank you for making the time to answer!Show Less
When the clock input to the REF pin is branched and output as it is, is there any difference in the connection method and usage between the CLKOUT and CLK1-4 pins?
This device has a total of 5 CLK output pins, CLKOUT and CLK1-4. Only CLKOUT has an internal feedback path. Therefore, I would like to know if there are any differences in characteristics from other output pins.
Looking for clock buffer with a programmable delay capability of delaying up to 100ns in large steps (10 steps 10ns is ok or even 4 steps of 25ns).
I could not find a direct solution for it but I did come across CY7B991V but the max delay it can program is 18ns.
I am looking at 100ns. Is there any solution for this?Show Less