cancel
Showing results for 
Search instead for 
Did you mean: 

Clocks

TyDi_4754026
New Contributor

https://www.cypress.com/file/43081/download

I was going through that data sheet on the CY22800 Frequency Multipliers since and since I'm trying to transform and external 1MHz clock signal to a 12MHz signal I was going to go with the -052A variant. My question is, which of Pins 5-7 is the 12 MHz signal going to be coming out of? And what voltage level should I tie pin 3 to in order to acheive this?

0 Likes
1 Solution
PradiptaB_11
Moderator
Moderator

Hi,

I am attaching the code specific one page datasheet for this dash code. You will get a output on pin 5 and pin 6. You will need to ground both the frequency select lines. Kindly go through the datasheet once and if the device suits your application requirements you can go for samples to test the device for your requirements.

Regards,

Pradipta.

View solution in original post

0 Likes
1 Reply
PradiptaB_11
Moderator
Moderator

Hi,

I am attaching the code specific one page datasheet for this dash code. You will get a output on pin 5 and pin 6. You will need to ground both the frequency select lines. Kindly go through the datasheet once and if the device suits your application requirements you can go for samples to test the device for your requirements.

Regards,

Pradipta.

View solution in original post

0 Likes