- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello all,
What is the CY2302 Loop filter Bandwidth?
Can I use it for jitter attenuation application?
Thanks
Nir
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi
The loop bandwidth is roughly about 100 KHz. As it is a public forum cannot share the exact number but you can use the mentioned value for all practical purposes.
As far as using it for Jitter attenuation go you will need to check the jitter which is already present in inside the bandwidth as that will be amplified. So if it is within the range for your application they you can use it for cleaning jitter.
Thanks,
Pradipta.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi
The loop bandwidth is roughly about 100 KHz. As it is a public forum cannot share the exact number but you can use the mentioned value for all practical purposes.
As far as using it for Jitter attenuation go you will need to check the jitter which is already present in inside the bandwidth as that will be amplified. So if it is within the range for your application they you can use it for cleaning jitter.
Thanks,
Pradipta.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thanks Pradipta.
Nir