Jun 15, 2021
07:58 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jun 15, 2021
07:58 PM
I have a Capsense liquid level sensor attached to plastic container that is 3 mm thick. With this setup I do not see any change in signal when water is added. What is the maximum wall thickness that this sensor will work? is it possible to increase the sensitivity?
Solved! Go to Solution.
Labels
- Labels:
-
Community Information
-
Help
1 Solution
Jun 25, 2021
06:34 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jun 25, 2021
06:34 AM
Hi @bill
You can use the 12-Rx strip of the 022 kit for evaluation. Please make sure that you connect both the Tx sensors to ground so that you obtain maximum coupling with ground in the design.
Best regards,
Hari
3 Replies