Featured Discussions
Hello.
Please advise if there are any code routines for all four use cases in this document. AN226043 - How to use sound subsystem in TRAVEO T2G family
smartconx_target@Q!w2e3r4t5y6u7i8o9p0||/t5/TRAVEO-T2G/Sound-subsystem-in-TRAVEO-T2G/td-p/717156
Show LessHi.
I'm a student. I have a PCB with the SAK-TC214L-8F133 chip on it. I would like to be able to connect to it using Memtool. I see Memtool supports this layout. I have a USB-UART converter.
How should I connect from the hardware side? Connect TxD from the converter to P14.1 (ASCLIN0_RXA) and RxD to P14.0 (ASCLIN0_TX)? I did that, but Memtool does not detect the chip. Do I need to short any configuration pins to VCC/GND?
I will be grateful for your help.
I'm having an issue with 30A TV. I've submitted a video, but it's not showing up on their channel. Does anyone have any advice on what I should do in this situation? I've checked their guidelines and made sure my video meets all the requirements, but it's still not being aired. Any insights or suggestions would be greatly appreciated. Thanks!"
Hi ,
I am trying to stream video data via FX3 coming from my fpga at 5200*3900 resolution at 15fps and not able to set min /max bit rate descriptor value as descriptor size is only 32 bit.
Desired value of the descriptor should be -
(width x height x data width x frame rate)
5200x3900x16x15 = 0x1221B9400
but this value is more than 32 bits.
how can I go ahead with above mentioned requirements?
Note - I have implemented a design taking AN75779 reference with same resolution but at 5fps and it is working fine now I wish to increase frame rate.
Thanks & Regards,
Akash
Show LessI've configured Icu module on DaVinci to detect PWM input signal frequency change and raise an interrupt for CPU intervention when the frequency changes from low to high.
However, I receive this error shown below:
ltc E106: unresolved external: Icu_17_TimerIp_Config - (EcuM_Callout_Stubs.o)
What would be the root cause?
Best,
B.
Show LessDoes TLE4263-2ES require an external pull-up at reset out?
Datasheet says it has an internal pull-up(30kΩ) but in the application circuit there is a 5.6kΩ pull up which is contradicting. (30kΩ parallel 5.6kΩ would reduce the pull-up effective resistance).
Show LessPART NUMBER ICL5102,The label read diffused in IRDUMMY, what does the IRDUMMY mean?
我使用libusb可以打开usb设备,但是无法烧写固件,我需要在执行烧录固件之前,还需要做什么步骤
Using Aurix Development studio, I have implemented standalone project for TC389 EVAL Board EDSADC with Single Ended channel configuration, selected channel is AN20CH2, with decimation factor 32, Full scale - 65535 for unsigned mode. Filters and integrator disable.
Giving input externally through function generator as below parameters:
Frequency: 100Hz, Amplitude: 1.5Vpp Offset: 2.5V
Observing positive half cycle little bit clamped for above function generator setting and amplitude more than 1Vpp, what can be issue? is it in configuration?
Show Less