Featured Discussions
Hi,
I am working with PSoC6 (CY8CKIT-062-WIFI-BT) and W5500 Ethernet Controller. PSoC and W5500 communicate using the SPI protocol. As mentioned in the W5500 datasheet, I have written a function. To read or write from the W5500, there are two functions: byte read or write, and SPI bus read or write.
For reading a byte, you need to send 3 bytes of data (address) and the last byte as a dummy byte for the response, totaling four bytes. According to the SPI protocol, there is a version register to read (0x39), and the expected response is 0x04. The data sent from PSoC to W5500 is (0x00, 0x39, 0x00, 0xFF), and the response is (0x01, 0x02, 0x03, 0x04). However, when I print the version register, it shows the response as 0x03. Why is it not reading the last byte?
I have attached the files below.
Show LessIt is possible to tap the ADC output from Radar Chip BGT60TR13C for using in the external hardware? If so kindly provide the details regarding that.
Show LessHi,
is there any solution or workaround available to install miniprog3 drivers on Windows 11 arm based machines, to be able to use the latest PSoC Programmer.
This is also related to:
https://community.infineon.com/t5/PSoC-4/Has-anyone-successfully-used-miniprog3-with-an-Arm-based-host/m-p/378995
Thanks and best regards,
Rico
Hi,
I'm Trying to implement Hall in IMC102T with Hall as a drive input, motor tries to run but its not running.
If anyone could suggest a solution for this it would be helpful thanks in advance
I had attached MCE wizard configuration file for your reference
Show LessHello! I would like to ask about the Kelvin structure IGBT used in air conditioner PFC, do I have to isolate the Kelvin ground E2 from the ground and E1 of the driver chip? Is it OK if I use a normal bottom-side gate driver?
smartconx_target@Q!w2e3r4t5y6u7i8o9p0||/t5/IGBT/%E5%BC%80%E5%B0%94%E6%96%87%E7%BB%93%E6%9E%84%E7%9A%84IGBT%E6%8E%A5%E5%9C%B0%E9%97%AE%E9%A2%98/td-p/717161
Show LessHello.
Please advise if there are any code routines for all four use cases in this document. AN226043 - How to use sound subsystem in TRAVEO T2G family
smartconx_target@Q!w2e3r4t5y6u7i8o9p0||/t5/TRAVEO-T2G/Sound-subsystem-in-TRAVEO-T2G/td-p/717156
Show Less