Featured Discussions
Hi ,
I am trying to stream video data coming from my fpga at 5200*3900 resolution at 15fps and not able to set min /max bit rate descriptor value as descriptor size is only 32 bit.
Desired value of the descriptor should be -
(width x height x data width x frame rate)
5200x3900x16x15 = 0x1221B9400
but this value is more than 32 bits.
how can I go ahead with above mentioned requirements?
Note - I have implemented a design with same resolution but at 5fps and it is working fine now I wish to increase frame rate.
Thanks & Regards,
Akash
Show LessI've configured Icu module on DaVinci to detect PWM input signal frequency change and raise an interrupt for CPU intervention when the frequency changes from low to high.
However, I receive this error shown below:
ltc E106: unresolved external: Icu_17_TimerIp_Config - (EcuM_Callout_Stubs.o)
What would be the root cause?
Best,
B.
Show LessDoes TLE4263-2ES require an external pull-up at reset out?
Datasheet says it has an internal pull-up(30kΩ) but in the application circuit there is a 5.6kΩ pull up which is contradicting. (30kΩ parallel 5.6kΩ would reduce the pull-up effective resistance).
Show LessPART NUMBER ICL5102,The label read diffused in IRDUMMY, what does the IRDUMMY mean?
我使用libusb可以打开usb设备,但是无法烧写固件,我需要在执行烧录固件之前,还需要做什么步骤
Using Aurix Development studio, I have implemented standalone project for TC389 EVAL Board EDSADC with Single Ended channel configuration, selected channel is AN20CH2, with decimation factor 32, Full scale - 65535 for unsigned mode. Filters and integrator disable.
Giving input externally through function generator as below parameters:
Frequency: 100Hz, Amplitude: 1.5Vpp Offset: 2.5V
Observing positive half cycle little bit clamped for above function generator setting and amplitude more than 1Vpp, what can be issue? is it in configuration?
Show Less
Dear Forum:
We are doing our soft with pSoC6 CY8C6137BZI-F14,
We use the Modus IDE.
But when we use psoc programmer to write Hex file produced by Modus,
psoc programmer show the following error:
Hex File parsing failure. Unknown record type.
Can you tell me the reason.
Thank you.
Show LessHello,
I am using SiC MOSFET GDB and power module for double pulse testing. The GDB was working fine until a few days ago when I saw a spark in the HS of the V-phase(I was using the LS of V-phase). After initial inspection of the GDB and power module, the RDY LS, RDY HS LED`s went off on the GDB.
On the power module, the measured impedance between Gate, Drain and Source were very less than the normal impedance on the other phases of the board. The condition on which the failure occurred was 500V and 350A. The SiC module was tested alot of times before the incident and there was no damage. Also the measurement setup was same as the earlier when there was no issue.
Please comment on the possibilities of the failure of the GDB or the power module. If you need more information then please let me know.
Thank you
Show LessHow to interpret the .npy files that we get in the Radar Fusion GUI. I used the np.load to load the contents of the array( image attached below),the shape of the array is correct, but i am not able to understand what the contents are? Is the contents of .npy file the raw ADC data or it is in byte format?
Show Less