WICED IBM IoT Bluemix quickstart
- Subscribe to RSS Feed
- Mark as New
- Mark as Read
- Bookmark
- Subscribe
- Printer Friendly Page
- Report Inappropriate Content
WICED connect to quickstart
Download and install the latest version of WICED SDK, available for Windows, Mac and Linux. To setup on Windows platform, follow the steps present in this link.
To connect to the Quickstart Service, follow these steps:
Open the WICED SDK eclipse base IDE
Under demo->IBM , place the bluemix_iot quick start project
The MQTT library implementation is included in the libraries and can be found under protocol section
WICED SDK setup :
Edit the wifi_config_dct.h under bluemix_iot as per your accesspoint credentials
In the make target window add the following new target ( for this example we have used BCM94343W hardware)
And click on build target for this make target. On successfull build and download the application to hardware, open any serial port communication like TeraTerm or Putty to see the hardware console output.
The below console message can be viewed
Enter the deviceId that you see in the console log, in the quickstart website to visualize the data points as shown below
IBM Internet of Things Foundation
At this step, we have successfully sent the sensor data to IBM Watson IoT Platform Quickstart service using the WICED hardware
- Subscribe to RSS Feed
- Mark Article as New
- Mark Article as Read
- Bookmark
- Subscribe
- Printer Friendly Page
- Report Inappropriate Content
Note, a "recipe" based on this but specifically targeting the Avnet BCM4343W IoT Starter Kit is available at:
https://developer.ibm.com/recipes/tutorials/avnet-bcm4343w-iot-starter-kit
- Subscribe to RSS Feed
- Mark Article as New
- Mark Article as Read
- Bookmark
- Subscribe
- Printer Friendly Page
- Report Inappropriate Content
If you are looking to do this with ZentriOS, a new tutorial was also uploaded to support IBM Bluemix with ZentriOS. Find the new tutorial here: Beginners guide to ZentriOS : IBM Bluemix
- Subscribe to RSS Feed
- Mark Article as New
- Mark Article as Read
- Bookmark
- Subscribe
- Printer Friendly Page
- Report Inappropriate Content
Broadcom BCM4343 SDK on developerWorks:
https://developer.ibm.com/recipes/tutorials/avnet-bcm4343w-iot-starter-kit/
BlueMix on Avnet's Cloud Marketplace