- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
good afternoon..........
I am trying to load or open a project ASSOCIATED WITH CY8CKIT-036 ( for CY8CKIT-001 KIT ) BUT this produce a lots of error and i am unable to see the topdesign component. There is problem in plcaing a component according to me.
i am using psoc creator 2.0. is this error due to cretor version or due to anything else.
error generated,while opening a file , is attached with this.
please help me..
thank you
- Labels:
-
PSoC 3
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Where did you get the projects from? Are they maybe newer than your PSoC Creator version? You should try with the latest version, which is 2.2.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
This is may due to version mismatch. Download PSoC 2.2 from Reference link
http://www.cypress.com/?id=2494&source=header.
Try on it.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
You are attempting to open a schematic with instances that cannot bound on it. This can happen when the project that you are using was created with a higher creator version with latest component versions. Try using latest PSoC creator version. IF you are sure that the project was created with same or older version, file a case.
-srim
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
thank you all
i have found the error and resovled it. it is a version problem.