Anonymous
Not applicable
Dec 11, 2012
10:00 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Dec 11, 2012
10:00 AM
Hi
i have problem that it's seem like power.
When i working fx2lp board and fpga board.
So i connect with both board for slave fifo working.
Fx2lp board is just connected USB cable( it's just use power from usb cable).
When i connect FPGA Board to Fx2lp board, FPGA Board's led is weak on.
it's seem like something wrong. but slave fifo is working well(stream project ).
I dont know what am i check ?
3 Replies
Anonymous
Not applicable
Dec 11, 2012
10:11 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Dec 11, 2012
10:11 AM
Addingly above post,
if i use 16bit slavefifo mode, which pin used for i2c in fx2lp-56pin?
how can i handle of this problem?
Anonymous
Not applicable
Feb 28, 2013
03:13 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Feb 28, 2013
03:13 AM
Do you mean to say, FX2LP is back-powering FPGA board even when FPGA is not supplied with any voltage?
Thanks
Nikhil
Attachments are accessible only for community members.
Anonymous
Not applicable
Mar 01, 2013
01:24 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Mar 01, 2013
01:24 PM