- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
there is a problem in programming of kit CY8CKIT-001 using miniprog3 in creator as well as designer.
error message is: can not accquire the device
if anybody know about this problem ,please help me
thank you
- Labels:
-
PSoC 1
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Check the following -
1) In project settings are you asking for external power or Miniprog supply power ?
2) Are power jumpers consistent on the DVK with project settings ?
3) Driver in Win Device manager look OK ?
Regards, Dana.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
i got the problem and resolve it.
thank you very much sir
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
i am faicnf the same problem in programming the kit-001 both designer and creator module can any body help me out with this
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Are you using Win 8 ?
Programming PSoC using Programmer on Windows 8 - KBA85688
Question: How to install PSoC Programmer and drivers on Windows 8?
Answer:
Kindly follow this procedure to program your PSoC device with Windows 8 OS:-
1) Upgrade your Programmer to 3.17 from the link “http://www.cypress.com/?rID=38050&source=header”.
2) This step is based on the type of OS:-
a. If your Windows is 32 bit then download “drivers_32bit.zip” file in your computer. Unzip this file and copy folder “drivers” at location “C:\Program Files\Cypress\Programmer\3.17\”.
b. If your Windows is 64 bit then download “drivers_64bit.zip” file in your computer. Unzip this file and copy folder “drivers” at location “C:\Program Files (x86)\Cypress\Programmer\3.17\”.
3) Go inside the folder “drivers” which you have copied and run the “driver.bat” file.
4) Plug-in MiniProg3 in the USB port of the PC, you should be able to see it in device manager.
5) And you will be able to program you devices now.
RRRegards, Dana.
Re
Re