Anonymous
Not applicable
Nov 18, 2014
12:27 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Nov 18, 2014
12:27 PM
Is there any debug possibility
UART?
From the code : ble_trace0 - ble_trace6 used to log the prints but it is defined dummy in bleapp.h
Is that legacy code ?
Solved! Go to Solution.
Labels
- Labels:
-
Debug
-
WICED Sense
1 Solution
Nov 18, 2014
12:43 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Nov 18, 2014
12:43 PM
Unfortunately there is not as the HCI UART Rx line is not accessible via a switch the way it is on the full featured TAG3 development board. On the TAG3 board, SW4 can be configured and the trace plugin within the IDE is then functional.
1 Reply
Nov 18, 2014
12:43 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Nov 18, 2014
12:43 PM
Unfortunately there is not as the HCI UART Rx line is not accessible via a switch the way it is on the full featured TAG3 development board. On the TAG3 board, SW4 can be configured and the trace plugin within the IDE is then functional.