- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I tried adding an olimex debugger to cypress FX3 board, but i am not able to do it !!
Got some help from this post http://www.cypress.com/?app=forum&id=167&rID=78322
But still i am getting an error which i have attached an image, please help
Thanks
Rags
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I found the solution , in the document one line of the configuration file has been given as 2 that is causing the problem .
Explained in the snap attached ,
jtag newtap $_CHIPNAME cpu -irlen 4 -ircapture 0x1 -irmask 0xf -
expected-id $_CPUTAPID
this has to be in config file as
jtag newtap $_CHIPNAME cpu -irlen 4 -ircapture 0x1 -irmask 0xf -expected-id $_CPUTAPID
Please change in the document
Thanks
Rags
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Are you following all the instruction given in Programmer's manual chapter 12?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Please double-check.
Otherwise we can have a quick team viewer session.
Thanks
Nikhil