- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
HI!
Is it possible to use gpio pins as control outputs in GPIF waveform?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
It is not possible. You can get 6 control pins in 128 package. Do you need more control pins? Please let me know your requirement in details so that we can help you better.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
I just forgot to set one control bit, but i set it as gpio pin. My schematic is ready and difficult to change it. So i think how to use this pin during Waveform.I see only one option: enable it before GPIF operation and disable after.
Regards,
Roman
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi PRJI....
I am working in L&T,we are using CY7c67300 USB controller in one of our product and we are facing some issues..
From this forum i came to know that you are the one who is expert in cypress controllers.
I have some queries regarding this..
So can you give your mobile number or mail ID?
if you are ready to give please send your mobile number to rakesh.k@lnties.com...