- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Dear RSKV,
From the forum I found the post " http://www.cypress.com/?app=forum&id=167&rID=64701" and you helped clh23047 to resolve the debug issue.
Now I have the same question ,and after I read the DVK_guide.pdf , Syusb3014 datasheet and the post , I also can not resolve the issue. and my com also can not print logs.
I used the SDK sample "USBVideoclass" as the test project , I have checked the jumper connect , and it is right ! Then I connect the DVK and PC use COM ! and the source code you can refer to the SDK.
I have not changed the initial code about IO matrix . and then I add some "CyU3PDebugPrint(4, "Hello PC COM\n");" statements.
However, when I start the firmware used AMCAP, there are no logs print in "SecureCRT" . And I checked the settings of SecureCRT , the setting is "com1-115200-8-none-1".
Can you tell me why ?? Thanks !
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
You are using DVK so please make sure that your DVK has these jumpers (J101,102,103,104) between 1 and 2.
Please try with the attached image file. Let me know if you are not receiving the debug messages with that image as well.
You will get messages like "USB LOG"...
Thanks,
Sai Krishna.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content