- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
HI
I have been using PSoC since 1.5 years with device model CY8C3865AXI-019, but after installing PSoC creator 2.2 (programmer v1.3) when I want to program the device it identifies the device as CY8C3865AXA-019.
I have found a solution for that select the device CY8C3865AXI-019 as CY8C3865AXA-019 and it will work fine...
I was using another model also CY8C3866AXI-040 ES2 but since I have updated the PSoC creator 2.2 I cannot program it....help Plz.
To program that device I have to run the program in PSoC creator 1 which creates problems in updated components.....
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Take a look at this - http://www.cypress.com/?id=4&rID=38529
and this http://www.cypress.com/?app=forum&id=2492&rID=80804
Basically Creator 2.2 removed most ES devices from their catalog. A board swap was
done some time ago. In general your best bet is to get the part replaced on the board
you have, if non Cypress, otherwise talk to local Cypress sales office to see if you can
swap out board/module you are using.
The exchange program - http://www.cypress.com/?app=kitupgrade
Regards, Dana.