- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
When using EZ-Serial firmware with CYBLE-212006-01, what is the state of the extended range feature ? The datasheet of the CYBLE (http://www.cypress.com/file/318881/download) describes a source code modification p15. Is it present in the EZ-Serial firmware ? Is there a command to enable or disable it ?
Thanks in advance
Solved! Go to Solution.
- Labels:
-
BLE
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Eric,
The extended range modifications are built into the EZ-Serial firmware and automatically enabled on any modules which support them. At the moment, there is no way to disable the behavior within EZ-Serial.
Jeff
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Eric,
The extended range modifications are built into the EZ-Serial firmware and automatically enabled on any modules which support them. At the moment, there is no way to disable the behavior within EZ-Serial.
Jeff