- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello ,
I would like to program a code for my CY4531 for allowing a secure connection between my USB 2.0 and USB Type-C thanks to crypto engine for authentication.
So I would like to know how I can I do that with PSoC Creator because i don't find my device in the list proposed in "Select Device" , does EZ-PD CCGx SDK (CCG3) in Target Hardware could be a good choice ?
Or should I use EZ PD-Configuration Utility or PSoCProgrammer ( which not contained my device too).
Regards ,
Solved! Go to Solution.
- Labels:
-
ispn:39569:1:0
-
l1:314:1:0
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Build the application projects using the PSoC Creator. The firmware binaries will be generated in ELF, HEX, and
CYACD formats suitable for SWD programming, Miniprog, and the EZ-PD configuration utility.
You can refer to the chapter 4 of the CY4531 Kit Guide for updating the firmware using EZ-PD config. Else you can also use PSoC programmer with a Miniprog to flash the firmware with SWD.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Build the application projects using the PSoC Creator. The firmware binaries will be generated in ELF, HEX, and
CYACD formats suitable for SWD programming, Miniprog, and the EZ-PD configuration utility.
You can refer to the chapter 4 of the CY4531 Kit Guide for updating the firmware using EZ-PD config. Else you can also use PSoC programmer with a Miniprog to flash the firmware with SWD.