- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
I just wanted to set a RTC to European standards for DST which is
DSTStart : Last Sunday in March
DSTEnd : Last Sunday in October
Since I can set the week with RTC_WriteDSTStartWeek(Week), there is not a chance to set Week to the LAST week.
Besides calculating the number of Sundays for a given month myself, I would rather prefer to specify "5" for the week and let the RTC adjust it to the correct value which would be 4 or 5 (There are never more than 5 Sundays in a month and never less than 4)
Is there a chance that the RTC-Module will be updated to reflect the European Standards as of 2000/84/EG ORDERING of DAYLIGHT-SAVING-TIME?
THX
Bob
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Bob,
there is a chance, yes. There have been quite some changes in daylight savings time over the last view years and I would be surprised if we wouldn't see more of these changes. I will make sure that the team responsible for the upcoming specifications gets your input!
Robert
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Robert,
sounds good! And btw: can we have a 24-hour clock as well?
Bob
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Bob
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hijacking a two-year-old thread with a new problem will reduce your chances of getting a good answer (its just less visible).
Thanks!
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
If you right click your RTC component, pick "Find example project", you can add
the example project to your workspace, or open it in a new workspace. Either way
you can cut and paste from the example project to get your up and running.
Regards, Dana.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content