Oct 03, 2013
05:59 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Oct 03, 2013
05:59 PM
Just encountered a strange problem. I took a project from 2.2 SP1 and imported it into 3.0. I can compile and execute the code just fine in Debug mode. However, when the code is compiled in release mode, it fails to execute. In other words, the processor appears to hang. This is on a CY8C4125.
I did not have this issue in 2.2 SP1.
Thoughts?
4 Replies
Anonymous
Not applicable
Oct 03, 2013
08:32 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Oct 03, 2013
08:32 PM
Hi Manjagu
Which part was in failing ?
Can you identify it ?
Did you make some special setting for Build ?
When I test in Release mode, same fail does not happen ever.
However, it is 8C4245
Which part was in failing ?
Can you identify it ?
Did you make some special setting for Build ?
When I test in Release mode, same fail does not happen ever.
However, it is 8C4245
Oct 04, 2013
11:10 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Oct 04, 2013
11:10 AM
It's a bit difficult to determine why the program has failed because all communications cease. The chip is a CY8C4125.
Oct 04, 2013
11:38 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Oct 04, 2013
11:38 AM
I would suggest you to IMMEDIATELY create a "MyCase" (Support&Community->Technical Support -> Create a MyCase) and submit a complete project workspace created with Creator (File -> Create Workspace Bundle)
Bob
Bob
Oct 04, 2013
01:43 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Oct 04, 2013
01:43 PM
Have done. Will see what they say. Thanks.