- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi, I have a new project developed in PSoC3, I need to establish Wi-Fi communication. The Ad-Hoc is ready but in EBK shows displayed message "RF Band select". I'm using this material:
Hardware
. Cypress, CY8CKIT-030 PSoC3
. RedPineSignals, RS-CY8C001-220X
Firmware
. LIB_TestPSoC3_UART.cywrk
Documentation
. RS-CY8C001-220X_EBK_User_Guide.pdf
Regards
BE Ezequiel Rivas
- Labels:
-
PSoC 3
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Done
Thanks
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Im using the Psoc 5LP kit. I cannot get this project to compile because it says embedded components in the -220X component are obsolete versions. Such as the SPI master and related components.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
OK, figured it out. The component is in its own folder. Open it as its own project, then update. then save and go back to main project and update components there. You also need to delete the folder created by GCC441 compiler and clean out everythign in the generated files folder. Doing a Clean on the project doesnt seem to get the files created with older GCC and are part of the zip file.