10 Replies Latest reply on Nov 14, 2013 4:38 PM by DaKn_263916

    Servo Motor Interface with PSoC 3

      Hi Fellow Community Members,




      Recently I got a chance to lay my hands on a simple servo motor (of type TS-53), which had to be interfaced with PSoC 3. Thought of sharing it on the forum.




      This interface required the PSoC to give a PWM signal with the high pulse varying between 1ms and 2ms. 1 ms corresponding to 0 degrees and 2ms corresponding to max rotation possible (close to 150 degrees in my case).


      The dead time between the two pulses was 40ms.


      The on-board potentiometer available on CY8CKIT-001 was used to vary the position of the shaft.




      The project is attached along with this post. It may come handy if someone is working on similar servos.